Installing Ac Power Modules; Prerequisites; Required Tools And Equipment; Steps - Cisco ASR 9000 Series Installation Manual

Installing AC Power Modules

Installing AC Power Modules

Prerequisites

There are no prerequisites for this task.

Required Tools and Equipment

You need the following tool to perform this task:
• 7/16 hex socket and torque wrench, torque 50 in-lb.

Steps

Follow these steps to reinstall the AC power modules back into the chassis (see
1 Power- Module, on page 160
3 Power Module in the Cisco ASR 9010, 9912, 9922 Routers, on page 161
power modules, and
page 161
Procedure
Step 1
Slide the power module into the power tray until it mates with its backplane connector.
Step 2 Secure the module:
• Version 1 power module: Pivot the power module door fully to the left until it locks to securely seat the
• Version 2 and version 3 power modules: Move the handle up and tighten the screw using the 7/16 hex
Step 3 Repeat for the other AC power modules.
Step 4
Go to
Caution
Figure 168: Installing a Version 1 Power- Module
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
160
for the version 1 power module,
Figure 170: Installing a Version 2 Power Module in the Cisco ASR 9904 Router , on
for installing a version 2 power module in the Cisco ASR 9904 Router.
power module to its backplane connector.
socket and torque wrench with the torque set to 50 in-lb.
Installing Fan Trays, on page 162
To prevent damage to the power tray backplane connector, do not use excessive force when inserting
the power module into the power tray.
Figure 169: Installing a Version 2 or Version
to install the fan tray.
Installing Cards and Modules in the Chassis
Figure 168: Installing a Version
for the version 2 and version 3