Cisco ASR 9000 Series Installation Manual page 273

Replacing Cisco ASR 9000 Series Router Components
Example:
Router# show redundancy summary
Active/Primary Standby/Backup
-------------- --------------
0/RSP0/CPU0(A)
0/RSP1/CPU0(P)
Step 2
Shutdown the standby RSP card (slot 1) using the admin hw-module shutdown location 0/RSP1 command.
Step 3 Remove the standby RSP card (slot 1). When RSP is removed, an alarm is generated indicating that the
redundancy is lost. Follow the procedure explained in the topic
Chassis, on page
Step 4
Insert RSP5 in slot 1 and allow RSP5 to bootup.
Step 5 Verify both the RSPs are in IOS XR RUN state using the show platform command.
Example:
Router#show platform
Node
--------------------------------------------------------------------------------
0/RSP0/CPU0
0/RSP1/CPU0
0/FT0
0/FT1
0/1/CPU0
0/FC0
0/FC1
0/FC2
0/FC3
0/FC4
0/PT0
0/PT1
Step 6 Verify RSP in slot 0 and RSP5 in slot 1 reach full synchronization (NSR-ready state) and status of ALL the
groups is Ready state. Use show redundancy command to verify the same.
Step 7 Manually copy Embedded Event Manager (EEM) scripts from RSP to RSP5 disks if applicable.
Note
Step 8 From active RSP, verify the both RSPs have synchronized the SNMP engine ID and SNMP ifindex-table
between each other:
Example:
#more disk0:snmp/ifindex-table loc 0/rsp0/cpu0
#more disk0:snmp/ifindex-table loc 0/rsp1/cpu0
#more disk0:snmp/snmp_persist loc 0/rsp0/cpu0
#more disk0:snmp/snmp_persist loc 0/rsp1/cpu0
Step 9 Perform redundancy switchover from active RSP to standby RSP5. This results in RSP5 (slot 1) becoming
active RSP and RSP (slot 0) becoming standby RP.
Example:
0/RSP1/CPU0(S) (Node Ready, NSR: Ready)
0/RSP1/CPU0(B) (Proc Group Ready, NSR: Ready)
245.
Type
A9K-RSP880-LT-TR(Active)
A9K-RSP5-TR(Standby)
ASR-9910-FAN
ASR-9910-FAN
A9K-8X100GE-TR
A99-SFC-S
A99-SFC-S
A99-SFC-S
A99-SFC-S
A99-SFC-S
A9K-AC-PEM-V3
A9K-AC-PEM-V3
The EEM scripts are files located on RSP's hard disk. These files are not automatically synced
between Active and Standby RSPs.
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
Migrating from RSP4/RSP4-S/RSP-L to RSP5 Card
Removing and Replacing Cards from the
State Config state
IOS XR RUN NSHUT
IOS XR RUN NSHUT
OPERATIONAL NSHUT
OPERATIONAL NSHUT
IOS XR RUN NSHUT
OPERATIONAL NSHUT
OPERATIONAL NSHUT
OPERATIONAL NSHUT
OPERATIONAL NSHUT
OPERATIONAL NSHUT
OPERATIONAL NSHUT
OPERATIONAL NSHUT
259