Removing A Version 2 Or Version 3 Ac Or Dc Power Module - Cisco ASR 9000 Series Installation Manual

Replacing Cisco ASR 9000 Series Router Components
Procedure
Step 1
Push the door latch to the left to release the door.
Step 2 Pivot the door to the right to eject the power module from its bay.
Step 3
Slide the power module out of its bay while supporting it with your other hand.
Caution
Figure 211: Removing or Installing a Version 1 AC or DC Power Module

Removing a Version 2 or Version 3 AC or DC Power Module

Follow these steps to remove a version 2 or version 3 AC or DC power module from the chassis (see figure
titled Removing or Installing a Version 2 or Version 3 AC or DC Power Module). The Cisco ASR 9904 Router
chassis only has one power tray as shown in the figure titled Removing or Installing a Version 2 AC or DC
Power Module from the Cisco ASR 9904 Router .
Procedure
Step 1 Pull the handle down.
Note
Step 2
Slide the power module out of its bay while supporting it with your other hand.
Use two hands to remove the power module. The power supply weighs about 6.5 pounds (2.95 kg).
Unscrew the screw that secures the power module using a 7/16 hex socket and torque wrench with
the torque set to 50 in-lb.
Cisco ASR 9000 Series Aggregation Services Router Hardware Installation Guide
Removing a Version 2 or Version 3 AC or DC Power Module
235