Table of Contents
Advertisement
Assembly
The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
Serious injury could occur if you connect
machine to power before completing setup
process. DO NOT connect to power until
instructed later in this manual.
To assemble machine:
1.
Mount machine to bench as described in
Bench Mounting on Page 14.
2.
Loosen both cap screws shown in Figure 13,
but do not remove.
Work Table
Position Screw
Figure 13. Wheel guard and work table position
cap screws.
Model G0898 (Mfd. Since 12/19)
Contact Wheel
Guard Screw
3.
Loosen grinder tilt lock screw (see Figure
14). Adjust grinder to upright position, then
tighten screw to secure.
Figure 14. Grinder tilt lock screw.
4.
Unscrew belt access door knob to open door
(see Figure 15).
Belt Access
Door Knob
Figure 15. Belt access door knob.
5.
Pull belt tension lever backward (see Figure
16), then slide included sanding belt over
wheels and platen.
Wheels
Figure 16. Lever positioned without tension.
Grinder Tilt
Lock Screw
Belt Tension
Lever
Platen
-15-
Advertisement
Table of Contents
