Adjusting Grinder Tilt - Grizzly G0898 Owner's Manual

Adjusting
Grinder Tilt
The G0898 can be positioned vertically or hori-
zontally, or anywhere in between, depending on
your operation (see Figure 28).
Figure 28. Grinder positioned for various
applications.
-22-
To adjust grinder tilt:
1. DISCONNECT MACHINE FROM POWER!
2. Loosen both cap screws shown in Figure 29,
but do not remove.
Work Table
Position Screw
Figure 29. Wheel guard and work table position
lock cap screws.
3.
While supporting grinder body, loosen cap
screw shown in Figure 30. If grinder is
upright it will fall back to a horizontal posi-
tion. Adjust and tighten cap screw at desired
angle.
Figure 30. Grinder tilt lock cap screw.
4. Adjust platen until it lightly contacts belt, then
tighten cap screws loosened in Step 2.
5.
Close belt access door and lock with knob.
Model G0898 (Mfd. Since 12/19)
Contact Wheel
Guard Screw
Grinder Tilt
Lock Screw