Grizzly G0898 Owner's Manual page 18

6. Center belt on wheels, then pull belt tension
lever forward.
7. Position platen so it barely touches back of
sanding belt (see Figure 17), then tighten
contact wheel guard cap screw from Step 2.
Figure 17. Proper platen adjustment.
— If you need to adjust platen angle, loosen
platen adjustment cap screws (see Figure
18), adjust platen, then tighten to secure.
Platen Adjustment
Cap Screws
Figure 18. Platen adjustment cap screws.
8. Close belt access door and secure with door
knob.
-16-
9.
Platen
10. Tighten work table position screw (see Figure
11. Proceed to Test Run.
Loosen table tilt screw and adjust table so
there is less than ⁄
1
16
(see Figure 19), then tighten screw to secure.
Table-Belt Gap
Table Tilt
Screw
Figure 19. Proper table position.
Table and belt form an in-running nip point
where one part moves past a stationary
object. Body parts may be caught in this
gap and be crushed or otherwise injured.
Minimize this risk by allowing no more than
⁄ " between table and belt.
1
16
20) to secure table position.
Work Table
Position Screw
Figure 20. Work table position cap screw.
Model G0898 (Mfd. Since 12/19)
" between table and belt
Work Table