Lcd Settings - ABB PowerValue 11 RT G2 User Manual

4 O P E R AT I O N
—

4 .6 LCD settings

WARNING
Press and hold select button for 5 seconds to enter UPS settings mode when UPS is in standby mode or
bypass mode. Press and hold "Off/Enter" and "select" buttons for 5 seconds to switch LCD screen in
rack or tower display.
Rack display
There are two parameters to set up the UPS.
Parameter 1: For program alternatives. Refer to table below.
Parameter 2: The settings options or values for each program.
—
01: Output voltage setting
Interface
02: Frequency converter enable/disable
Interface
CHANGING UPS SETTINGS MIGHT ADVERSELY IMPACT THE LOAD SUPPLY OR LOAD FUNCTIONALITY. IT IS
RECOMMENDED TO DISCONNECT THE LOAD BEFORE PROCEEDING
Parameter 1
VAC
H %
z
VDC
H
M
Parameter 2
Settings
Output voltage
VAC
You may choose the following output voltage:
208: output voltage is 208 Vac
220: output voltage is 220 Vac
230: output voltage is 230 Vac (default)
240: output voltage is 240 Vac
Settings
Parameter 1: Enable or disable converter mode. You may choose from the following two
options:
CF ENA: converter mode enable
CF DIS: converter mode disable (default)
Tower display
VAC
H % Parameter 1
z
VDC
H
Parameter 2
M
21