Table of Contents
Advertisement
5
User Interface Reference
The Measurement Parameters
Measure Mode
82
•
After loading a setup with user calibration mode set to "Load", the
specified calibration file is preselected in the load dialog asking you for
the calibration data file during OE or OO initialization.
For more details, see
Measuring Opto-Electrical (OE) devices
or
Measuring Optical-Optical (OO) Devices
Figure 16
Graphical user interface of the LCA software
A 2-port network analyzer can only support single-ended measurements.
Selecting the Measure Mode is only possible if you have a 4-port network
analyzer.
Keysight N4372E Lightwave Component Analyzer User's Guide
on page 54
on page 70.
Advertisement
Table of Contents
