Setting Functions - Assa Abloy ESA500 Programming Instructions Manual

Programming

Setting functions

Functions are always entered according to the same formula:
<Function code> , <Parameter 1> , (<Parameter 2> ), (<Parameter 3> )
(„Table of function codes", page 30)
Between one and three parameters must be entered depending on the function.
Example of a function with one parameter:
Enter function
1 Enter the function code for the desired function and confirm with the  key.
9 The signal LED flashes orange.A brief signal sounds.
2 Enter parameter 1 for the desired function and confirm with the  key.
9 The signal LED lights up green.A long signal sounds.
3 Repeat step 2 if the function requires additional parameters.
9 The function has been entered successfully.
Delete entries
1 Press the X key to delete the last entry.
Example:
The user entry 70  11 X
corresponds to 70 .
Invalid entries
If an impermissible entry is made and confirmed with , the electronic door
fitting flashes red once and three brief signals sound.The entry can be carried out
again.
Example:
The user entry 72  2 
corresponds to 72 ,
because only the values 1 and 0 are permitted for parameter 1 of function 72.
EN
29