Add Network Camera Through Poe - HIKVISION DeepinMind Series User Manual

6. Optional: Check Verify Certificate to verify the camera with certificate. The certificate is a form
of identification for the camera that provides more secure camera authentication. It requires to
import the network camera certificate to the device first when you use this function. For details,
refer to .
Note
The function is only available when you use HIKVISION protocol.
7. Click Add.
8. Optional: Check Continue to Add to add other network cameras.

1.4.3 Add Network Camera Through PoE

The PoE interfaces enable the device system to pass electrical power safely, along with data, on
Ethernet cabling to the connected PoE cameras. Supported PoE camera number varies with device
module. If you disable the PoE interface, you can also connect to the online network cameras. And
the PoE interface supports the Plug-and-Play function.
Add PoE Camera
Steps
1. Go to Camera → Camera → PoE Settings .
2. Enable or disable long network cable mode by selecting Long Distance or Short Distance.
Long Distance
Long-distance (100 to 300 meters) network transmissions via PoE interface.
Short Distance
Short-distance (< 100 meters) network transmission via PoE interface.
Note
• The PoE ports are enabled with the short distance mode by default.
• The bandwidth of IP camera connected to the PoE via long network cable (100 to 300 meters)
cannot exceed 6 MP.
• The allowed max. long network cable may be less than 300 meters depending on different IP
camera models and cable materials.
• When the transmission distance reaches 100 to 250 meters, you must use the CAT5E or CAT6
network cable to connect with the PoE interface.
• When the transmission distance reaches 250 to 300 meters, you must use the CAT6 network
cable to connect with the PoE interface.
• Refer to the Appendix 20.3 List of IP Cameras Connected to PoE by Long Network Cable (100 -
300 m) for the list of IP cameras.
Network Video Recorder User Manual
10