ZiLOG ZNEO Series Quick Start Manual page 8

®
ZNEO Series of Microcontrollers Development Kit
Applying Power to the Development Board
Follow the steps below to apply power to the ZNEO development board:
1. After installing the USB Smart Cable, connect the power supply to the development
board at connector P1, then to an electrical outlet.
2. The green 3.3 V DC LED illuminates, indicating that power is being supplied to the
board.
Getting Started Using ZDS II
Follow the steps below to open and use the
project. This project is designed to compile and download into ZNEO internal Flash
Memory and blink the development board LEDs.
Note:
These procedures reference the
in the below path:
c:\Program Files\ZiLOG\ZDSII_ZNEO_<version_number>\
samples\QuickStart\
where
For example,
c:\Program Files\ZiLOG\ZDSII_ZNEO_4.10.1\
samples\QuickStart\
1. To run the sample project with the ZDS II debugger enabled, set the jumpers on the
development board as follows:
– J1 OUT
– J2 OUT
–
J3 IN
–
J6 OUT
–
J7 OUT
–
Switch S2 in the RUN position
QS005703-0908
<version_number>
Z16F2800100ZCOG.zdsproj
Z16F2800100ZCOG.zdsproj
is the ZDS II version number.
sample
file located
Page 8 of 18