Advertisement
®
ZNEO
Series of Microcontrollers Development Kit
Configuring the 5 V DC Universal Power Supply
The universal power supply kit features several different plug adapters in one box and the
power supply in another. The power supply ships with a slide-out plate that must be
removed to insert the location-specific plug adapter.
If a location-specific adapter plug is required, follow the steps below to install it:
1. Remove the slide-out plate.
2. Select the AC plug adapter appropriate for your locale and insert it into the slot that
remains after removing the slide-out plate.
3. Slide the new plug adapter into the slot until it snaps into place.
You can leave the adapter slot cover in place and plug in a standard computer equipment
AC power cord (purchased separately) between the AC cord receptacle on the end of the
power supply and an electrical outlet.
Setting Up the Development Board
Setting up the ZNEO development board involves setting its jumpers and using the USB
Smart Cable to connect the board to a high-speed or full-speed USB port on your ZDS II
host system.
Caution:
Always use a grounding strap to prevent damage resulting from
electrostatic discharge (ESD).
Figure 1
displays a photograph of the ZNEO development board.
QS005703-0908
Page 2 of 18
Advertisement
