ZiLOG ZNEO Series Quick Start Manual page 6

®
ZNEO Series of Microcontrollers Development Kit
Windows XP
Follow the steps below to install the USB Smart Cable for Windows XP:
1. Connect the USB Smart Cable to the host PC for the first time.
The Found New Hardware wizard will activate automatically.
2. In the Wizard, select Install from a list or specific location (Advanced); then click
Next.
Note: If the Windows Logo testing dialog appears, select Continue Anyway.
3. Select Search for the best driver in these locations and Include this location in
search.
4. Browse to one of the following driver directory:
<Zilog Developer Studio II Installation Directory>\
device drivers\USB
<Zilog Developer Studio II Installation CD>\Device Drivers\USB
5. Click Next, and then click Next again after the appropriate driver is found.
6. Click Finish to complete the installation.
Windows 2000
Follow the steps below to install the USB Smart Cable for Windows 2000:
1. Connect the USB Smart Cable to the host PC for the first time.
The Found New Hardware wizard should activate automatically.
2. In the Wizard, click Next.
3. Select Search for a suitable driver for my device (Recommended); then click Next.
4. Select Specify a location; then click Next.
5. Browse to one of the following driver directory:
<Zilog Developer Studio II Installation Directory>\
device drivers\USB
<Zilog Developer Studio II Installation CD>\Device Drivers\USB
6. Click OK, and then click Next after the appropriate driver is found.
7. Click Finish to complete the installation.
QS005703-0908 Page 6 of 18