Printing On Thick Paper (0.5 Mm To 1.5 Mm) - Epson Stylus Pro 7500 Reference Manual

Printing on thick paper (0.5 mm to 1.5 mm)

When you load thick cut sheets, follow the steps below.
Note:
When you use paper other than EPSON special media, or print using
the RIP (Raster Images Processor), refer to the appropriate instructions
or contact your supplier for more information.
1. Set the paper basket forward, if you have installed the
optional Stand. See "When feeding paper forward" on page
4-21.
2. Make sure that the printer is on.
3. Press the Paper Source button repeatedly until the Sheet
light comes on.
4. Make sure that the Operate light and Pause light are not
flashing, then push the paper set lever all the way down. LOAD
PAPER appears on the LCD panel. Open the lower cover by
pulling down on the handles.
Paper Handling
4-19