Replacement of the TM-T70
The TM-T70II is designed so that it can smoothly replace the TM-T70. This chapter describes
precautions for the replacement.
Compatibility
Printing
The printing and character specifications are the same as those of the TM-T70. Without special
configurations, the TM-T70II prints the same results as the TM-T70 prints.
Print Density
The print density of the TM-T70II can be set with the memory switch as can the TM-T70.
For detailed information about the memory switch, see
Receipt Enhancement" on page
Number of Head Energizing Parts
For the TM-T70II, the initial setting of the number of head energizing parts is "One-part
energizing." You can change the setting with the memory switch (See
Switches/Receipt Enhancement" on page
Number of head energizing parts
Printable Area (for 80 mm Width Paper/58 mm Width Paper)
The printable area (left/right margins, print start position from the autocutting position, print
start position from the manual cutting position) of the TM-T70II is the same as that of the
TM-T70.
Chapter 5 Replacement of the TM-T70
54.
54.); however it does not usually need to be changed.
TM-T70II
One-part energizing
Two-part energizing
"Setting the Memory Switches/
"Setting the Memory
TM-T70
58 mm width paper printing
One-part energizing/Two-part
energizing/Auto energizing
80 mm width paper printing
One-part energizing/Two-part
energizing
5
97