Epson Stylus Pro 7500 Reference Manual page 24

CUTTER LIFE, TOTAL PRINTS, WASTE INK, CR MOTOR (Carriage
motor life), PF MOTOR (Paper feed motor life), HEAD UNIT
(Head unit life), CLEANER (Cleaning unit life)
For maintenance service personnel only.
Paper Configuration menu (PAPER CONFIG. MENU)
This menu allows you to register four kinds of paper thickness
together with ink drying time and suction setting from 1 to 4. You
can select whether the paper thickness is determined
automatically (STD (standard)) or by the registered value (1, 2, 3,
or 4). You can also register the ink drying time and suction setting
for the STD setting. The procedure for registering and recalling
the paper thickness setting is described in "Setting the paper
thickness" on page 1-18.
Note:
When you are loading very thin paper, set the Suction setting to LOW.
Otherwise, the paper may not be ejected properly and paper error may
occur.
Cutter Replacement menu (CUTTER REPLACE MENU)
This menu enables you to replace the paper cutter. For a detailed
description, see "Replacing the Paper Cutter" on page 5-5.
Head Alignment menu (HEAD ALIGNMENT MENU)
This menu allows you to correct any head misalignment to obtain
optimum printing results. For details, see "Performing the head
alignment" on page 1-16.
You can perform the head alignment using the utility included in
the Software CD-ROM shipped with the printer for the paper
supplied by EPSON.
1-14
The Control Panel