Setting The Paper Thickness - Epson Stylus Pro 7500 Reference Manual

7. Press the Enter button to register the set number. The next
pattern number appears. Repeat step 6.
8. After you set the pattern(s), press the Pause button to return
to READY status.
Note:
You can return to step 6 by pressing the Enter button.

Setting the paper thickness

When you use media other than EPSON special media, you may
need to set the paper thickness. You can select whether the
thickness of the paper you are using is determined automatically
(STD (standard)) or by the registered value (1, 2, 3, or 4) in the
Paper Configuration menu. To register and recall the settings you
made, see the following sections. You can also register the ink
drying time and suction setting for respective paper settings
including STD. To select the registered setting, see "Selecting the
registered settings" on page 1-21.
Registering the settings
To register the paper thickness and ink drying time settings,
follow the steps below.
1. Load the paper you want to check and register its thickness
in your printer, as described in "Using Roll Paper" on page
4-3 or "Using Cut Sheet Media" on page 4-15.
Note:
When you load roll paper, select Roll Cutter Off. Depending on the
kind of paper used, automatic cutting may not be possible.
2. In SelecType mode, press the SelecType button until PAPER
CONFIG. MENU appears on the LCD panel.
3. Press the Item button. You may see PAPER NUMBER = STD*.
1-18
The Control Panel