3.13 FIXTURE SETTINGS
It is possible to change the parameter value in the following way:
Dimmer
• Enter in Dimmer mode to select specific dimming curve, press the button MENU so many times
until shows [DIM MODE], and press the button ENTER to confirm.
• Press the button UP/DOWN to select [Off - DIM1 - DIM2 - DIM3].
• Press ENTER button to store.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
BackLite
• To activate Backlight display press the button MENU so many times until shows [BACKLITE], and press
the button ENTER to confirm.
• Press the button UP/DOWN to select [On - 10S - 20S - 30S].
• Press ENTER button to confirm the selection.
• Press the MENU button to go back or to meet the waiting time to exit from the setup menu auto-
matically.
3.14 FIXTURE INFORMATION
Auto Test
Allow checking the proper functioning of the unit. Start the automatic test in the following way:
• Press the button MENU so many times until shows [INFO], then press the ENTER button to confirm.
• Using the button UP/DOWN to select [AUTO TEST].
• To confirm and start the automatic test press the ENTER button.
FixHours
Show the fixture working hours.
• Press the button MENU so many times until shows [INFO]. Press the button ENTER to confirm
• Using the button UP/DOWN to select [FIXHOURS], then press the button ENTER to confirm
• Then the display will show the working hours.
• Press the MENU button to go back or to meet the waiting time to exit from the setup menu auto-
matically
Version
Show the fixture firmware version.
• Press the button MENU so many times until shows [INFO]
• Select through the button UP/DOWN the [VERSION] menu voice.
• The display will show the firmware data.
• Press the MENU button to go back or to meet the waiting time to exit from the setup menu automatically.
LUMIPAR7VWPRO
13