Fixture Settings; Information; Remote Control Ec800 (Optional) - ProLights BEAMROLL8Q User Manual

16

3.13 FIXTURE SETTINGS

It is possible to change the parameter value in the following way:
Setting projector functions
Press the button MENU, set the desired parameter using UP/DOWN and press the button ENTER to
confirm the setting.
• bLMd - Blackout function. Select YES or no if want, respectively, enable or disable the function.
• LEd - Back light display. Select on or oFF if want, respectively, enable or disable the back light display
function.
• diSP - Reversing display screen. diSP deactivate the function (display shown in the normal mode), diSP
activate the function (display shown in inverted mode).
• 1tiL - Reverse Tilt movement of the moving head 1. no disables the function (normal setting), YES
activate the function (reverse tilt).
• 2tiL - Reverse Tilt movement of the moving head 2. no disables the function (normal setting), YES
activate the function (reverse tilt).
• rev - reverse mode of the LEDs illumination. YES activated (the LED will light up on both heads moving
in reverse), no disables the function (the same LEDs will light up on both head units).
• tEst - test device. In tEst the unit will run self-test.
Hold and press the button MENU for three seconds to exit the menu mode.
Reset functions
Press the button MENU so many times until the display shows rSET, then press the button ENTER to reset
the default values.

3.14 INFORMATION

Fixture information
Press the button MENU, set the desired parameter using UP/DOWN and press the button ENTER to
confirm the setting.
• vEr - Through the vEr function you can display the software version of the device.
• tEMP - Through the tEMP function you can display the temperature of the projector.
• FhrS - Through the FhrS function you can display the running time of the projector.
Hold and press the button MENU for three seconds to exit the menu mode.

3.15 REMOTE CONTROL EC800 (optional)

The remote control EC800 (fig.7) available as an accessory allows to control different functions as indicated
in the table below:
Fig.7
BEAMROLL8Q
BUTTON
BLACKOUT
1. Sound Strobe (Full ON)
FUNCTION
2. Auto Strobe (Full ON)
MODE Random Show (LED OFF)
FUNCTION
Blackout the unit
Select Show
Show 1 - 8
Show (LED ON)