Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
Your new 5530 Grain Drill comes nearly com-
pletely assembled from the factory and ready to go
to the field. This section includes press wheel and
option assembly procedures .
To insure alignment of assemblies, leave the
nuts loose until completion of final assembly. Use
lock washers or flat washers as specified. Spread
all cotter pins.
After completion of final assembly, tighten
all nuts evenly to prevent misalignment, distortion
or binding. Tighten all screws and nuts to the rec-
ommended torques shown in Table 2-1, "Standard
Bolt Torques".
DANGER
OPENER BLADES ARE EXTREMELY
SHARP. EXERCISE EXTREME CARE
WHEN WORKING ON OR NEAR
OPENER BLADES. DO NOT ALLOW
OPENER BLADES TO ROLL OVER OR
FALL ONTO ANY BODY PART. DO NOT
ALLOW WRENCHES TO SLIP WHEN
WORKING NEAR BLADES. NEVER
PUSH WRENCHES TOWARD OPENER
BLADES. DO NOT CLIMB OVER MA-
CHINE ABOVE OPENER BLADES.
FAILURE TO STAY CLEAR OF OPENER
BLADE EDGES CAN CAUSE SERIOUS
PERSONAL INJURY OR DEATH.
WARNING
DO NOT ATTEMPT TO LIFT HEAVY
PARTS (SUCH AS THE FRAME, WHEEL
LIFT, AND PULL HITCH) MANUALLY.
USE A HOIST OR A FORKLIFT TO
MOVE THESE PARTS INTO POSITION.
DANGER
TO PREVENT ACCIDENTAL LOWER-
ING:
1. ALL HYDRAULICALLY ELEVATED
EQUIPMENT MUST BE LOCKED OUT
USING THE CYLINDER LOCKOUTS.
2. LOWER EQUIPMENT TO THE
GROUND WHILE SERVICING OR
WHEN IT IS IDLE.
FAILURE TO TAKE MEASURES TO
PREVENT ACCIDENTAL LOWERING
MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH.
CAUTION
BE SURE TO BLEED THE HYDRAULIC
SYSTEM OF ALL AIR IN LINES AFTER
INSTALLATION. FAILURE TO BLEED
THE SYSTEM OF ALL AIR CAN RE-
SULT IN IMPROPER MACHINE OPERA-
TION.
3
3-1
Hide quick links:
Advertisement
Table of Contents
