Configuring The Veritas Remote Management Interface - VERITAS 5150 Hardware Installation Manual

3
4
Configuring the Veritas Remote Management
Interface
Veritas Flex Appliance release 1.x does not support configuring the IPMI port through
the Flex Appliance Shell.
To configure the dedicated Veritas Remote Management Interface (IPMI) LAN
settings in the BIOS
1
2
3
On the bottom, left, rear of the appliance verify that the LED on each power
supply is green.
Proceed to the next section to configure remote management.
Connect a standard video cable between the VGA (Video Graphics Array) port
and the computer monitor
Connect a keyboard to a USB port at the rear of the Flex 5150 appliance.
Ensure that the power cords are connected to a power supply and press the
power switch on the front panel.

Configuring the Veritas Remote Management Interface

Installation procedures 28