Table of Contents
Advertisement
Maintenance
32
Operating Manual ZR 26-I
Insert the two O-rings [420] into the corresponding counter bores of the flank [400].
Now attach the flank on the base body [10] so that the location bolt fits into the cor-
responding bores of the base body.
Flank [400] and base body [10] are screwed together by using the four cylinder head
screws [130].
Slide the excentric ring [110] onto the guide ring; insert the insert plates [120] into the
notches of the excentric ring. Screw in the cylinder head screws, but don't tighten
them.
By using the match code [310], the excentric ring is brought into the right position
(refer to scale).
Insert the gear segment [150] and the clamping piece [160] and screw them together
by means of the two cylinder head screws [170] and tighten the cylinder head screws
[140].
16.3. Verifying of the mode of operation
The assembled unit guide- and excentric ring needs to slide smoothly on the base
body.
Advertisement
Table of Contents
