Mounting Of The Cutting Head Onto The Machine - WAGNER ZR26-I Operating Manual

Mounting of the cutting head onto the machine

24 Operating Manual ZR 26-I
10. Mounting of the cutting head onto the machine
The thread cutting head ZR 26 I is usually mounted rotating with stagnant workpiece.
However, it can be mounted stagnant with rotary workpiece, too.
In addition to the thread cutting head, we deliver the suitable mounting flange for the
machine and the connector for the connecting rod.
A machine requirement is a connectable connecting rod which is resistant to tension
and pressure.
The cutting head can be mounted completely assembled and preset on the drive
screw. The connector is coupled via a left–handed thread with the connecting rod and
the flange is mounted on the shaft.
The nature of mounting is machine-dependent and is done either by a screw connec-
tion or an attachment bracket. (See chart on page 27)