Connections And Control Devices; Cooling Liquid Connection - ESAB Robust Feed PRO Instruction Manual

5 OPERATION
5.2

Connections and control devices

1. External control panel (see the
"CONTROL PANEL" chapter)
2. BLUE connection for cooling liquid to the
1)
welding torch
3. RED connection for cooling liquid from
1)
the welding torch
4. Connection for the Tweco trigger cable
(only in combination with Tweco torch)
5. Connection for the remote control unit
(optional)
6. Connection for the welding torch (Euro
or Tweco type)
7. Internal control panel (see the
"CONTROL PANEL" chapter)
8. Heat kit switch (Offshore versions)
NOTE!
1)
Cooling liquid connections are only available on certain models.
WARNING!
The right and left side doors of the wire feed unit must be closed and locked when
welding and/or wire feeding occurs. Never weld or feed the wire unless both doors
are closed.
5.3

Cooling liquid connection

When connecting a liquid-cooled welding torch, the main power supply switch of the power
source must be in the OFF position and the cooling unit switch must be in position 0.
A liquid cooling kit can be ordered as an accessory (see the "ACCESSORIES" appendix).
0463 691 001
9. Wire inlet for use with Marathon Pac™
(optional)
10. Interconnection strain relief for cables from
power source
11. Connection for welding current from power
source (OKC)
12. RED connection for cooling liquid to the
power source (the cooling unit)
13. BLUE connection for cooling liquid from
the power source (the cooling unit)
14. Connection for shielding gas
15. Connection for control cable from power
source
- 19 -
1)
1)
© ESAB AB 2019