Table of Contents
Advertisement
SECTION 2
REGULATOR/
FLOWMETER
GAS HOSE
40V77 (12-1/2 FT.)
34V38 (25 FT.)
WATER KIT - 994466
WATER "DRAIN" HOSE - 40V76 (12-1/2 FT.)
ADAPTOR - 45V11
LEFT TORCH
MOTOR/ACC. SUPPORT
TORCH CONDUIT
TORCH POWER CABLE
TORCH WATER HOSE
TORCH GAS HOSE
TORCH SWITCH
LEFT TORCH
(WATER COOLED)
2.1 GENERAL
Proper installation can contribute materially to the sat-
isfactory and trouble-free operation of the wire feeder.
It is suggested that each step in this section be carefully
studied and followed as closely as possible.
After checking to be sure you have all required compo-
nents and accessories (see Section 1), proceed as
follows (with reference to Figs. 2-1 & 2-2, Interconnec-
tion Diagrams):
Parts required when
using a Water Kit & Water
Cooled Torch.
Fig. 2-1 - Torch and Service Interconnection diagram
WATER "IN" HOSE - 40V76
(12 1/2 FT.)
FRONT VIEW
CONTROL
To avoid possible lethal shock make sure that all
power to the Digimig is OFF before making any
welding/control cable and or accessory connec-
tions on this unit. Do this by "locking-open" the
input line disconnect switch to the power source.
2.2 CONNECTIONS
A. Hose And Electrical Connections
Connect shielding gas and water (if used) supply hoses
as shown in Fig. 2-1. Connect the control cable assem-
bly (J1) from the Digimig's rear panel to the power
source as shown in Fig. 2-2.
INSTALLATION
REGULATOR/
FLOWMETER
GAS HOSE
40V77 (12-1/2 FT.)
34V38 (25 FT.)
PLAN VIEW DUAL FDR.
GAS SOLENOIDS
REF. CONTROL'S REAR
SUPPORT FRAME
RIGHT TORCH
MOTOR/ACC. SUPPORT
TORCH CONDUIT
TORCH SWITCH
TORCH POWER CABLE
TORCH GAS HOSE
RIGHT TORCH
(AIR COOLED)
9
Advertisement
Table of Contents
