Introduction; Equipment - ESAB Robust Feed PRO Instruction Manual

2 INTRODUCTION

2 INTRODUCTION
The Robust Feed PRO wire feed unit is intended for MIG/MAG welding in conjunction with
the following welding power sources:
• Warrior™ 400i CC/CV
• Warrior™ 500i CC/CV
• Warrior™ 400i MV
• Warrior™ 350i MV
The wire feed unit comes in different versions (see the "ORDERING NUMBERS" appendix).
The wire feed units are sealed and contain four-wheel drive wire feed mechanisms as well as
control electronics.
They can be used together with wire on ESAB's Marathon Pac™ or on wire bobbin (standard
Ø 200 mm and Ø 300 mm).
The wire feed unit can be placed on a trolley, suspended above the workplace or on the floor
(standing up or laying down and with or without a wheel set).
ESAB accessories for the product can be found in the "ACCESSORIES" chapter of
this manual.
2.1

Equipment

Robust Feed PRO is supplied with:
• Instruction manual
0463 691 001 - 12 - © ESAB AB 2019