Setting The Gas Flow; Rotating The Control Panel - ESAB Robust Feed PRO Instruction Manual

6 CONTROL PANEL
6.6

Setting the gas flow

The gas flow is adjusted using the knob on the internal control panel. The
present gas flow rate is given on the gas flow meter above the knob.
NOTE!
The reading on the flow meter scale will only be correct if the wire
feeder is in upright position.
6.7

Rotating the control panel

To use the wire feeder in the horizontal position, the external control panel may be rotated
90°.
1. Remove the two screws for the control panel and remove the panel.
2. Rotate the control panel 90° counter-clockwise.
3. Attach the control panel, ensuring that the small tabs are in the correct position.
4. Fasten the screws.
0463 691 001 - 35 - © ESAB AB 2019