ESAB Robust Feed PRO Instruction Manual page 30

5 OPERATION
1. Attach the torch strain relief to the wire feed unit, using the two Torx 5 screws.
2. Attach the wheel kit to the wire feeder using the two screw joints near the rear end of
the wire feeder. Ensure that the two distance washers are inserted between the wheel
kit and the wire feeder.
3. Fasten the wheel kit and the torch strain relief to the wire feeder using the two screw
joints located closer to the front end of the wire feeder.
0463 691 001 - 30 - © ESAB AB 2019