Operation - ESAB Robust Feed PRO Instruction Manual

5 OPERATION

5 OPERATION
General safety regulations for handling the equipment can be found in the "SAFETY"
chapter of this manual. Read it through before you start using the equipment!
WARNING!
To avoid shock, do not touch the electrode wire or parts in contact with it, or
uninsulated cable or connections.
NOTE!
When moving the equipment, use the handle intended for transportation. Never pull
the equipment by the welding torch.
WARNING!
Make sure the side panels are closed during operation.
WARNING!
To prevent the reel from sliding off
the brake hub, lock the reel in place
by tightening the brake hub nut.
NOTE!
Replace the brake hub nut and the
brake hub sleeve if they are worn
out and don't lock properly.
CAUTION!
Before threading welding wire, make sure the chisel point and burrs have been
removed from the end of the wire to prevent the wire from jamming in the torch liner.
WARNING!
Rotating parts can cause injury, take great care.
0463 691 001 - 17 - © ESAB AB 2019