Dataprobe iBoot-WiFi Manual page 19

set linkback <url>
set timeout <0-999>
Autoping Commands
get autoping
set autoping <1 | 2> ipaddress <dotted
decimal>
set autoping <1 | 2> frequency <1-999>
set autoping <1 | 2> failcount <1-999>
set autoping mode <single | and | or>
set autoping action <none | on-latch | on-
follow | off-latch | off-follow | cycle>
set autoping cycle <0-999>
set autoping wait <1-999>
User Commands
set user account <yes | no>
set login required <yes | no>
set password <user | admin> <old>
<new> <repeat>
Event Commands
get events
Pre-Compliance v180808n
Note: At least one of the above MUST NOT be 0. The CLI will
protect against all 3 from being set to 0.
This command sets the linkback URL displayed on the logout
page.
This command sets the automatic network timeout in minutes
These commands require a reboot before they will take effect.
These commands are available to the administrator only.
This command returns all of the AutoPing settings as shown below.
AutoPing 1
IP Address: 192.168.233.254
Frequency: 10
Fail Count: 3
--------------------------------
Mode: Single
Action: Cycle Once
This command is used to set the IP address of AutoPing 1 or
AutoPing 2
This command is used to set the frequency (how often the iBoot-
WiFi sends the ping) for each of the AutoPings.
This command is used to set the number of consecutive failures
the AutoPings must detect before the AutoPing considers the
pinged device to be failed.
Sets single AutoPing (AutoPing 1) or two AutoPing relationship And
or Or.
This command is used to set the action that the iBoot-WiFi will
perform when the autoping triggers.
This command sets the maximum number of power cycles when
the AutoPing triggers. 0 = Unlimited
This command sets the time, in seconds for the device to respond
to a ping.
These commands are only available to the administrator.
This command sets whether or not a user account is used. If <n>
only the administrator account is active
This command sets whether or not a login is required for user level
operation. A login is always required for admin functions.
This command is used to set the password of either the user or
administrator.
These commands are only available to the administrator.
This command displays all scheduled events as shown below. Example:
Date Time Repeats
1. 01/13/2013 16:00 every
2. 01/13/2013 16:15 every
3. 01/15/2013 17:00 every
4. 02/16/2014 12:00 every
5. 02/16/2014 12:10 every
6. 02/17/2013 01:05 every
7. 02/18/2013 01:00 every
iBoot-WiFi
AutoPing 2
192.168.233.154
10
3
Action
1 Day(s) On Run
0 Day(s) On Run
1 Hour(s) Cycle Run
1 Day(s) Off Run
1 Day(s) On Run
0 Day(s) On Run
0 Day(s) On Run
2
Factory
Defaults
10
3
Single
None
1
2
n
y
user
admin
Factory
Defaults
Page 19