Node Mounting Locations - Raven SmarTrax Installation Manual

C 4
HAPTER
2. Remove the nuts from the machine's mounting plate.
NOTE: The machine's mounting plate is located behind the operator's seat.
3. Screw the M6 x 40 mm M/F to 13mm hex standoffs (P/N 305-8000-008) onto the top two studs of the
machine's mounting plate.
FIGURE 3. Node Installed
4. Mount the node mounting plate on the installed standoffs and secure with the machine's existing nuts that
were previously removed.

NODE MOUNTING LOCATIONS

FIGURE 4. Node Mounting
When choosing the location for the SmarTrax node, consider the following points:
• Mount the SmarTrax node inside the machine's cab on a flat, level surface for proper performance and cable
connection.
• One of the six numbered direction arrows on the node must be oriented in the direction of forward vehicle
travel, one arrow pointing straight up, and two of the arrows parallel to the ground.
NOTE: Make a note of the number of the arrow that is oriented in the direction of forward vehicle travel. This
number will be needed during the SmarTrax calibration process.
• The node mounting location must not create tripping hazards.
• Mount the node in a location where it will not be kicked or jarred during normal equipment operation.
20
Direction Arrows
Any two arrows
must be parallel
with level ground
SmarTrax, Case Trident 5550, Non-Steer Ready Installation Manual
5
1
2
4
3
Mounting
Tabs