Program Scans - Sam4s ER-900 Series Technical Manual

Program Scans

Since much time and energy has been invested in the planning and programming of your
advisable to print a hard copy of the final program for future reference.
OTHER PROGRAM SCANS
PLU PROGRAM SCAN
MACRO PROGRAM SCAN
1. Turn the control lock to the PGM position.
2. To print a program scan, enter 1 5, then press the SBTL key.
1 5 SBTL
3. In this step, there are three different ways to scan program information.
One is PLU, the other is Macro, the third is Others.
To read a single PLU code program information, enter the number of the PLU
and press PLU No. key, then repeat the same PLU No.
Enter the PLU#,
up to 15 digits
or
Press a PLU key on the keyboard and press the same key again.
PLU 1 PLU 1
To read multiple PLU program information, then enter the first number and
press the PLU No. key. Then enter the last number and press PLU No. key.
Enter the first
PLU#, up to 15
digits
or
Press the first PLU key on the keyboard, followed by the last PLU key
PLU 1 PLU 10
To read MACRO information, press the MACRO key to be scanned,
MACRO# MACRO#
Refer to the chart below and enter a digit to represent the segment of the
program you wish to print, then press the QTY/TIME key. Repeat this
operation as required.
Enter the PLU#,
PLU
up to 15 digits
Enter the last
PLU#, up to 15
PLU
digits
ER-900
, it is
PLU
PLU
59