NEC PA1004UL-W User Manual page 79

NOTE:
• Upon switching to 3D image, the following functions will be cancelled and disabled. [BLANKING], [PIP/PICTURE BY PICTURE],
[GEOMETRIC CORRECTION], [EDGE BLENDING] (As the adjusted values of [GEOMETRIC CORRECTION] and [EDGE BLENDING] are
maintained, when you switch to 2D picture, the adjusted screen will be displayed again.)
• The output may not automatically switch to a 3D video depending on the 3D input signal.
• Check the operating conditions described in the user manual of the Blu-ray player.
• Please connect the DIN terminal of the 3D emitter to the 3D SYNC of the main projector.
• The 3D eyewear allows videos to be viewed in 3D by receiving synchronized optical signals output from the 3D emitter.
As a result, the 3D image quality may be affected by conditions such as the brightness of the surroundings, screen size, viewing
distance, etc.
• When playing a 3D video software on a computer, the 3D image quality may be affected if the computer CPU and graphics chip
performance are low. Please check the required operating environment of the computer that is stated in the operating manual
attached to the 3D video software.
• Depending on the signal, [FORMAT] and [L/R INVERT] may not be able to be selected. Please change the signal in that case.
When videos cannot be viewed in 3D
Please check the following points when videos cannot be viewed in 3D.
Please also read the operating manual attached to the 3D eyewear.
Possible reasons
The selected signal does not support 3D output.
The format for the selected signal is turned to
[OFF(2D)].
A eyewear that is not supported by the projector is
being used.
Please check the following points when a video
cannot be viewed in 3D using a 3D eyewear that is
supported by the projector.
The power supply of the 3D eyewear is turned
off.
The internal battery of the 3D eyewear is flat.
The viewer is located too far away from the
screen.
Due to multiple 3D projectors working at the
same time in the vicinity, the projectors may in-
terfere with one another. Alternatively, there may
be a bright light source near the screen.
There is an obstacle between the optical receiver of
the 3D eyewear and the 3D emitter.
The 3D format of the 3D video contents is not sup-
ported.
Please change the video signal input to one that
supports 3D.
Please change the format in the on-screen menu to
[AUTO] or a format that supports 3D.
Please purchase a commercially-available 3D eye-
wear or 3D emitter (recommended). (→ page 53)
Please turn on the power supply of the 3D eyewear.
Please charge or replace the battery.
Please get closer to the screen until the video can be
seen in 3D.
Please turn the [L/R INVERT] in the on-screen menu
to [OFF].
Please maintain sufficient distance between the
projectors.
Please keep the light source away from the screen.
Please turn the [L/R INVERT] in the on-screen menu
to [OFF].
Please remove the obstacle.
Please check with the company selling the 3D video
contents.
55
3. Convenient Features
Solutions