Adjustment method
1. Align the cursor with the [WARP] of the [GEOMETRIC CORRECTION] menu and the press
the ENTER.
•
Adjustment screen will be displayed on.
2. Press the ▼▲◀▶ buttons to align the cursor (blue box) with the target adjustment point
and then press the ENTER.
•
The cursor will change into an adjustment point (yellow in color).
3. Press the ▼▲◀▶ buttons to adjust the corners or sides of the screen and then press the
ENTER.
•
The cursor will back to yellow box.
Explanation for correcting distortion
•
Eight adjustment points can be moved independently.
For left and right sides, use ◀/▶ buttons for adjusting the range of distortion, and ▼/▲
•
buttons for adjusting the distortion peak.
For top and bottom sides, use ▼/▲ buttons for adjusting the range of distortion, and ◀/▶
•
buttons for adjusting the distortion peak.
•
For corners, use ▼▲◀▶ buttons for moving positions.
a
d
f
4. For adjusting other points, repeat Step2 onwards.
5. When the adjustment is completed, move the cursor onto the [EXIT] on the adjustment
screen and press the ENTER.
•
The screen will be switched to the [GEOMETRIC CORRECTION] menu.
The adjustment completion screen will be displayed on.
6. Press ◀ or ▶ button to move the cursor onto [OK] then press [ENTER].
•
The adjusted values for [WARP] are stored and the screen display goes back to the [GEO-
METRIC CORRECTION].
TIP:
• A commercially available USB mouse is available to perform correction. (→ page 49)
b
b
c
a
e
d
f
h
g
g
c
e
h
117
5. Using On-Screen Menu