NEC PA1004UL-W User Manual page 178

Turning On the Projector by Detecting Input Signal [AUTO POWER ON SELECT]
Under the state of standby or sleep, the projector automatically detects and projects synchronizing
signal input from the selected terminals among [COMPUTER], [HDMI1], [HDMI2], [DisplayPort], and
[HDBaseT] by this function.
OFF
HDMI1, HDMI2, DisplayPort,
COMPUTER, HDBaseT*
WARNING
• The projector produces intense light. When the power is turned on, make sure no one within
the projection range is looking at the lens.
NOTE:
• If you want to activate this [AUTO POWER ON SELECT] function after powering OFF the projector, interrupt the signal from the input
terminals or disconnect the computer cable from the projector and wait for more than 3 seconds (1 minute or longer if the input
signal is HDBaseT) and then the input signal from the selected terminal. In addition, if signal from HDMI1, HDMI2, DisplayPort or
HDBaseT is continuously input to the projector, the projector may be turned ON again automatically based on the setting of external
devices even if the projector is turned OFF and in the condition of SLEEP mode.
• This function is not activated either by component signal input from the computer screen input terminal or computer signal as
Sync on Green and Composite Sync.
Enabling Power Management [AUTO POWER OFF]
When this option is selected you can enable the projector to automatically turn off (at the selected
time: 0:05, 0:10, 0:15, 0:20, 0:30, 1:00) if there is no signal received by any input or if no operation
is performed.
Using Off Timer [OFF TIMER]
1. Select your desired time between 30 minutes and 16 hours: OFF, 0:30, 1:00, 2:00, 4:00,
8:00, 12:00, 16:00.
2. Press the ENTER button on the remote control.
3. The remaining time starts counting down and it is displayed at the bottom of the On-Screen
Menu.
4. The projector will turn off after the countdown is complete.
NOTE:
• To cancel the preset time, set [OFF] for the preset time or turn off the power.
• When the remaining time reaches 3 minutes before the projector is turned off, the [THE PROJECTOR WILL TURN OFF WITHIN 3
MINUTES.] message will be displayed on the bottom of the screen.
[AUTO POWER ON SELECT] function becomes inactive.
When the projector detects the computer signal input from the selected terminal, automatically it
will be turned [ON] and will project the computer screen.
154
5. Using On-Screen Menu