NEC PA1004UL-W User Manual page 133

TIP:
• Lens memory adjustments will be automatically registered the [ENTRY LIST]. These lens memory adjustments can be loaded from
the [ENTRY LIST]. (→ page 93)
Note that performing [CUT] or [ALL DELETE] in the [ENTRY LIST] will delete lens memory adjustments as well as source adjustments.
This deletion will not take effect until other adjustments is loaded.
• For storing each adjustment of [LENS SHIFT], motorized [ZOOM], and motorized [FOCUS] as common value for all input signal, store
them as [REF. LENS MEMORY].
To store your adjusted values in [LENS MEMORY]:
1. Project the connected device signal you want to adjust.
2. Adjust the projecting image of position, size and focus by the SHIFT/HOME POSITION,
ZOOM +/−, and FOCUS +/− buttons.
• Adjustment can be performed by the remote control. Please refer to "2-5 Adjusting the
Picture Size and Position" on page 26.
• Slight adjustment by moving the projector position and by the tilt foot is not subject of
[LENS MEMORY].
3. Move the cursor on [STORE] and press ENTER.
4. Move the cursor on [YES] and press ENTER.
To call up the adjusted values from [LENS MEMORY]:
1. From the menu, select [ADJUST] → [LENS MEMORY] → [MOVE] and press the ENTER but-
ton.
The confirmation screen will be displayed.
109
5. Using On-Screen Menu