Code Blue Event Fails To Trigger - Primex XR Levo Series Troubleshooting Manual

Code Blue Event Fails to Trigger

Problem
A Code Blue Event Fails to Trigger.
Cause
A Code Blue Timer is a multifunction digital clock and timer that integrates with an existing Code Blue system to effectively time
each event.
When a Code Blue event is invoked, a relay/pulse is sent from the Code Blue system to the Code Blue Timer, which triggers it to
l
begin counting up.
If a Code Blue event is in effect, it will take priority and the timer's previous task will run in the background until the Code Blue
l
event ends or is stopped.
A switch control allows the user to operate the timer in multiple modes.
l
In the event of a power outage, the timer's memory maintains the correct time for up to one hour.
l
Solution
Assistance from the Code Blue System provider may be needed to resolve this issue.
1. Inspect the wiring from the Code Blue Timer to the Code Blue System. Wiring is determined by the Code Blue System as
specified below. T he supplied 4-pin connector integrate the Code Blue System to the Code Blue Timer.
Code blue systems that apply a voltage to start a code blue event: wire the timer 4 pin connector's RED (Positive Code Blue
l
Input) and BLACK (Negative Code Blue Input) wires to the code blue system. Cap off the WHITE and GREEN wires separately.
An input voltage of 5-120V (AC or DC) can be used. When using DC, be sure to use the correct polarity; RED wire is positive
and the BLACK wire is ground. Code Blue start and stop events are triggered by the application of voltage across the code blue
input wires.
Code blue systems that use a dry contact and do not inject a voltage: wire the timer 4 pin connector's GREEN (Ground) and
l
BLACK (Negative Code Blue Input) wires together and wire the WHITE (12VDC) and RED (Positive Code Blue Input) wires to the
code blue system dry contact.
14
XR Levo Series Digtial Clock & Timer Troubleshooting Guide