Table of Contents
Advertisement
2
Installing a Dual-Radio System
This section describes how to install all components in a dual-radio system,
including downloading NTIDs and removing link J4, installing the radio
bodies and control head, connecting the radio system to a power source,
and installing antennas and remote speakers.
2.1
Overview of Steps Required
Before you start, make sure you have all the necessary tools and
components. See
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
TM9456 Dual-Radio Installation and Programming Guide
© Tait Limited July 2016
page 13
for more information.
Check that the all devices in the radio system have the same
firmware, and the radio bodies have the necessary software features.
See
"Checking the Firmware Versions and Software Features" on
page
19.
Download Network IDs to all devices in the system. See
"Downloading Network IDs" on page
Remove link J4 from the radio body interface that will be connected
to the control head. See
Assemble the body interfaces. See
Interfaces" on page
22.
Mount the radio bodies. See
page
23.
Install the radio connecting cable. See
Connecting Cable" on page
Install the antennas. See
Connect the radios to a power source. See
Cables to a Power Source" on page
Connect remote speakers (see
page
31).
Install the control head or heads. See
Solution" on page
31.
Install the fuses and check the installation. See
Installation" on page
36.
19.
"Removing Link J4" on page
"Assembling the Body Remote
"Mounting the Radio Bodies" on
"Installing the Radio
24.
"Installing the Antennas" on page
"Connecting the Power
28.
"Connecting Remote Speakers" on
"Installing the Control Head
Installing a Dual-Radio System
21.
26.
"Checking the
18
Advertisement
Table of Contents
