Table of Contents
Advertisement
Figure 2.7
Installing the
Remote Cable
and the control head.
Figure 2.7
to radio
body with
link J4 fitted
1.
2.
3.
TM9456 Dual-Radio Installation and Programming Guide
© Tait Limited July 2016
contains an overview of the connection between the radio bodies
Connecting radio bodies to control head with graphical-display
UHF body with link J4 removed
outermost
innermost
port
port
control head remote
cable T02-00009-0103
(6 m / 19.6 ft.)
Notice If a radio body does not have link J4 removed, or you cannot
identify the correct radio body to use, you will need to disassemble one
or both interfaces. See
"Removing the Body Interface" on page 22
more information.
Attach one end of the control-head remote cable to the innermost
port of the radio body with link J4 removed.
The outermost port of this radio body connects to the other radio body.
Attach the other end of the control-head remote cable to the rear port
of the control head remote interface.
Install the cable grommets. See
Grommets" on page
control head
"Removing and Installing
17.
Installing a Dual-Radio System
CH port
for
34
Advertisement
Table of Contents
