Tait TM9456 Installation And Programming Manual page 32

The following steps show how to connect the control head remote interface
Assembling the
Control Head
to the control head.
Interface
1.
2.
3.
4.
5.
6.
TM9456 Dual-Radio Installation and Programming Guide
© Tait Limited July 2016
Undo the two Torx T-
20 screws on the
adaptor flange of the
control head, and
remove the adaptor
flange.
Keep the two screws
for step 6.
Unplug the control-
head loom.
The adaptor flange and
control-head loom are
not used for the remote
control-head
installation.
Notice You can change the control head orientation by changing the
control-head loom to the opposite connector. For more information,
refer to the remote control-head installation instructions (IPN 402-
00020-xx, available from support.taitradio.com).
Plug the control-head
interface loom into the
connector on the
control head.
Use the two Torx T-20
screws from the first
step to fit the control-
head remote interface
to the control head.
Installing a Dual-Radio System 32