Installing The Radio; Mounting And Removing The Control Head - Tait TM9100 Installation Manual

2

Installing the Radio

Introduction
2.1

Mounting and Removing the Control Head

Mounting the Control Head
TM9100 (40W/50W) Installation Guide
© Tait Electronics Ltd October 2004
This chapter provides the information required to:
mount and remove the control head
select a safe and convenient mounting position
mount the radio
install the microphone and microphone clip
install the antenna
connect the power cable
connect a remote speaker
connect to the auxiliary connector
carry out installation checks
The radio body and the control head and its connection loom are delivered
separately. Before installing the radio, the control head should be mounted
on the radio body.
The orientation of the radio body determines which way up the control
head is mounted on the radio body.
Note
It may be required to mount the radio upside down in order to
maintain a gap of more than 3/8 inch (10 mm) for air circulation
between the underside of the radio body and the mounting.
Figure 2.1 Mounting the control head
1. Plug the control-head loom onto the control-head connector.
2. Insert the bottom edge of the control head onto the two clips in the
front of the radio body, then snap into place.
13