Tait TM9456 Installation And Programming Manual page 22

1.
Removing the Body
Interface
2.
2.4.2 Assembling the Body Remote Interfaces
The following steps show how to connect a body remote interface to a radio
body. Complete these steps for both radio bodies.
1.
TM9456 Dual-Radio Installation and Programming Guide
© Tait Limited July 2016
On the underside of the
radio, insert a 5 mm
(3/16 in.) flat-bladed
screwdriver between the
body interface and the
seal, in the positions
shown (Figure 2.3).
Insertion points and are
lever points and are indi-
cated on the radio chassis
by a dot-dash-dot pattern ( •
Caution Take care that the seal is not damaged. Damage to this seal
reduces environmental protection.
Use the screwdriver to lift the remote interface off the chassis clip,
then repeat in the other position.
You should now be able to inspect, and if necessary remove, shorting
link J4. It is not necessary to remove the body interface loom or the
earthing tag to remove the link.
Notice One remote interface must have link J4 removed. See
"Removing Link J4" on page 21
the interface with link J4 removed, make sure you can identify that radio
body when connecting the cables afterwards. If necessary, mark the
radio body with an appropriate label or similar.
Screw the
earthing tag onto
the left screw
boss on the radio
chassis, using the
Torx T-10 screw
provided.
Figure 2.3 Removing the body interface
–
• ).
for more information. After you install
Installing a Dual-Radio System
lever point
seal
indication of
lever point
22