Installing The Radio In The U-Bracket - Tait TM8105 User Manual

Installing the radio in the U-bracket

1
2
3
4
36 Radio installation
the self-drilling screws. Reduce the hole size in metal that
is less than 1mm (1/32 inch) thick.
Connect the antenna and power cables to the rear of
the radio.
Position the radio in the U-bracket so that the holes in the
U-bracket line up with the holes in the radio chassis.
Screw the radio into position using the four thumb screws
but without fully tightening the screws.
Position the radio in the U-bracket for best viewing angle,
then tighten the thumb screws.