The Notation In This Guide - Riso GOCCOPRO 100 User Manual

The Notation in This Guide

In this guide, notations are used in the following manner.
Indication of Precautions
The following icons are used throughout the guide.
Ignoring this warning could cause death or serious injury.
Ignoring this caution could cause injury or damage to property.
Indicates items that require special attention or that are prohibited actions.
Read carefully and follow the directions as instructed.
Gives you useful information.
Indicates a reference page.
Indication of Descriptions of Operations and Functions
Descriptions of functions and operations are indicated as follows.
Setting a New Screen Master Roll
Set a Screen Master Roll in the machine.
If the <REPLACE MASTER> Indicator on the Control Panel is lit, also perform the fol-
lowing procedure to replace the screen master.
<REPLACE MASTER> Indicator
• For the Screen Master Roll, it is recommended to use the products
specified by Riso.
• Keep the power On while replacing the Screen Master Roll.
1 3
Turn on the machine.
ON
2
4
Hold the Screen Making Unit Cover Handle and
open the cover.
24
5
Grasp the Screen Making Unit Open Lever and
open the Screen Making Unit
6
Open the Screen Master Roll Holder.
7
To replace the screen, remove the depleted Screen
Master Roll.
Dispose the depleted Screen Master Roll
according to the disposal rule of your local
community.
see "Disposal of a Depleted Screen
Master Roll" on page 83
2) If the screen master is loose, turn the flange
Install a new Screen Master Roll.
at the right inward to rewind.
Do not remove
the wrapper.
mark must be seen on the left.
Do not remove the wrapper yet.
If you cannot insert the leading edge of the
screen master well:
1) Close the Screen Master Roll Holder.
1) Turn the wheel beside the Screen Master
Guide Flap inward to raise the Screen Mas-
2) Remove the wrapper.
ter Guide Flap.
2) Pull out the Screen Master Roll up to the
line indicated by the arrows.
3) Close the Screen Master Guide Flap.
1) Insert the leading edge of the Screen Master
Roll into its entrance under the
Screen Master
Guide Flap until it stops.
8
Close the Screen Making Unit.
9
Close the Screen Making Unit Cover.
25
3
1 Chapter title
Preparations for Use for the First Time
Operating procedure
An operating procedure is
described in steps. Follow
Screen Master Guide Flap
these steps to perform oper-
ation.
Operation illustration
Flange
Shows a part related to the
operation described in the
respective step. A screen on
the Control Panel of the
machine or on the computer
is displayed.