Alarm] / Troubleshooting Menu; Alarm Messages; Alarm: [Power Unit]; Alarm: [Power Unit & Cell] - ProMinent CHLORINSITU IIa Assembly And Operating Instructions Manual

[ALARM] / Troubleshooting menu

[ALARM] / Troubleshooting menu
8
MENU
Status
Settings
Service
Fig. 14: Evaluating alarm messages, Chlorinsitu

8.1 Alarm messages

[POWER UNIT]
8.1.1 Alarm:
Alarm: POWER UNIT
[POWER UNIT & CELL]
8.1.2 Alarm:
Alarm: Current too low
32
OFF
l/h
® IIa
Pressing the
[ALARM] menu. In the [ALARM] menu you can scroll through
the
the error list by pressing the
[RESET] deletes all error messages and you can operate
Pressing
the system again, although faults that continue to exist will lead to
another alarm.
User qualification, troubleshooting: Service, see
n
'User qualification' on page 8
This alarm occurs if the actual current lies significantly below the
setpoint. The following causes are possible:
One of the power units is faulty (if there are 2 or more power
n
units).
The fuse is defective.
n
This alarm occurs for one of the following causes:
There is insufficient brine in the electrolysis cell.
n
One of the power units is too hot or faulty (if there are two or
n
more power units).
The analogue control for the power units is not working cor‐
n
rectly.
The analogue feedback signal of the actual current is not cor‐
n
rect.
WARNING!
Danger of explosion due to hydrogen
Fires and other ignition sources in the system's
vicinity or the air exhaust line can ignite the
hydrogen.
No. Time Date
[ATTENTION] icon in the [MAIN MENU] takes you to
[ScrollUp] and [ScrollDown] buttons.
Status
Text
Error message text
Error message text
Error message text
Error message text
Error message text
Error message text
Error message text
Error message text
Error message text
Error message text
Error message text
Error message text
Error message text
Ä Chapter 1.3
A2939