U.s. Customary Units - Mitsubishi Electric MELSERVO-JET MR-JET-G-N1 Series User Manual

Interpreting servo parameter numbers
For servo parameters that select a function with each digit in hexadecimal, the detail number is indicated on each digit.
The detail number at the far right digit is shown as [Pr. PA01.0]. In addition, when a servo parameter is set with a combination
of multiple digits, the servo parameter is shown with "-" as in [Pr. PA01.0-1].
The following shows a notation example of a servo amplifier, in which the number is PA01 and setting value is "FEDCBA98" in
hexadecimal.
• When setting each digit
[Pr. PA01] =
F E D C
• When setting multiple digits in combination
[Pr. PA01] =
F E D C
For example, when the servo parameter name is "Function selection A-1", the setting digit name is "Forced stop deceleration
function selection", and the servo parameter number is the fourth digit in PA04, the servo parameter is shown as follows.
[Pr. PA04.3 Forced stop deceleration function selection]
Servo Symbol
parameter
PA04.3 *AOP

U.S. CUSTOMARY UNITS

U.S. customary units are not shown in this manual. Convert the values if necessary according to the following table.
Quantity
Mass
Length
Torque
Moment of inertia
Load (thrust load/axial load)
Temperature
4
B A 9 8
Detail No.
PA01.0 = "8"
PA01.1 = "9"
PA01.2 = "A"
PA01.3 = "B"
PA01.4 = "C"
PA01.5 = "D"
PA01.6 = "E"
PA01.7 = "F"
B A 9 8
Detail No.
PA01.0-1 = "98"
PA01.2-4 = "CBA"
PA01.5 = "D"
PA01.6 = "E"
PA01.7 = "F"
Name
Forced stop deceleration function
selection
SI (metric) unit
1 [kg]
1 [mm]
1 [N•m]
-4
1 [(× 10
1 [N]
N [°C] × 9/5 + 32
Description
Set "Forced stop deceleration function" to enabled/disabled.
Initial value: 1h (Enabled)
2
kg•m )]
U.S. customary unit
2.2046 [lb]
0.03937 [inch]
141.6 [oz•inch]
2
5.4675 [oz•inch ]
0.2248 [lbf]
N [°F]