Table of Contents
Advertisement
Installation Instructions for Escutcheon Trim
1
Install chassis.
Route chassis connector through the upper 5/8" hole on the
interior side of the door, and pull through the slack as you
slide chassis into mortise. You may use needle-nose pliers to
gently pull the cable through the hole.
Hole
INTERIOR
2
Install lever spindle on the exterior side of the door.
Install spring on lever spindle.
6
Continue for installation
instructions for your lock with
escutcheon (Addison) trim.
For sectional
(Greenwich)
trim
instructions
go to page 3.
NOTICE
Start screws
but don't fully
tighten until
Step 9!
EXTERIOR
3
Install mounting posts and spring cage.
Arrows on the spring cage points in direction of lever down
rotation. Use pliers to carefully install mounting posts to avoid
damage.
4
Install the outside trim and route wire all the way through
the hole to the interior side of door.
Route wire from
outside trim above
wire from the chassis.
NOTICE
Arrows in
direction of
lever down
rotation.
Advertisement
Table of Contents
