Table of Contents
Advertisement
Installation Instructions for Sectional Trim
1
Install chassis.
Route chassis connector through the upper 5/8" hole on the
interior side of the door, and pull through the slack as you
slide chassis into mortise. You may use needle-nose pliers to
gently pull the cable through the hole.
Hole
INTERIOR
2
Install lever spindle on the exterior side of the door.
Install spring on lever spindle.
Continue for installation
instructions for your lock with
sectional trim (Greenwich).
For
escutcheon
(Addison) trim
instructions
go to page 6.
CAUTION
Start screws
but don't fully
tighten until
Step 12!
EXTERIOR
3
Install spring cage into lever.
Use pliers carefully to install mounting posts to avoid damage.
4
Install outside lever.
5
Install the outside trim and route wire all the way through
the hole to the interior side of door.
Route wire from
outside trim above
wire from the chassis.
IMPORTANT
Arrows in direction
of lever down
rotation.
Fully tighten mounting
posts on screws.
EXTERIOR
EXTERIOR
3
Advertisement
Table of Contents
