Table of Contents
Advertisement
6
Partly install the key cylinder.
Turn key cylinder into the chassis. Tighten just enough to
secure outside trim. Insert key, then pull out one notch to aid
with turning.
7
Install inside spindle, spring cage, and mounting plate.
Arrow on the mounting plate faces in direction of lever down
rotation.
NOTICE
Arrows in
direction of lever
down rotation.
8
Install the inside rose and lever.
4
NOTICE
Do not tighten more
than six full turns!
Tighten fully at step 12!
INTERIOR
*included in box
9
Connect the cables to the inside assembly.
There are two cables that need to be connected.
10
Deadbolt (LEMD) Only: Align driver bar into the
chassis.
Thumbturn should be vertical when deadbolt is retracted.
11
Install the inside assembly.
Cable slack
should be folded
downward.
Actual Size
Advertisement
Table of Contents
