Table of Contents
Advertisement
12
Fully tighten the key cylinder and chassis screws.
The cylinder face needs to be flush to the outside escutcheon.
Tighten the cylinder mounting screw.
Cylinder
mounting
screw
13
Install the armor plate.
14
Connect the battery cable.
Install four (4) AA batteries into the battery holder. Tuck the
cable behind the tab in the escutcheon.
Electrical Ratings (6Vdc, 500mA, 3 W)
Power On Self Test (POST)
The POST is a self-diagnostic test that the lock runs to
verify that the lock is installed correctly. The POST takes
approximately 30 seconds after batteries are installed.
During the POST, a series of audible beeps and LED
flashes will occur. If the POST detects an issue, the test will
conclude with three red flashes of the outside LED. Once
commissioned with the ENGAGE mobile app, any issues
identified during POST can be viewed under the View Activity
menu.
15
15a Optional: Install security screw and washer.
Remove standard screw and washer and replace with
security screw and washer.
16
Your lock is now completely installed.
After holder
is installed,
tuck cable
behind tab.
Install the battery cover and tighten the screw.
Continue to User Guide.
Access online interactive
instructions, user guide,
warranty, and reference
information.
alle.co/LE
5
Advertisement
Table of Contents
